Ku 2010

A General Blog Started In 2010 By KU!

Dec

28

iPad Backlight Repair Works Even After Water Damage Occurs

By admin

Iphone Ipad posterThe backlight on the back of the Apple iPad is a necessity. It is made to illuminate the entire screen to make it easier to read. However, the backlight can wear out after a while and might have to be repaired. A plan for iPad backlight repair needs to be handled in order to get this all fixed up the right way.

The first pat of checking on the backlight includes taking a look at any backlight bleeding issues. This includes dead pixels that might not be working. Backlight bleeding can be noticed when there appears to be a substantial difference in terms of how the backlight is illuminating certain images on the screen. This includes noticing bright spots at the ends of the iPad screen.

This can cause some dead pixels to occur because they will look the same no matter what a person is using on the iPad. This is a real problem that can particularly occur after the iPad is damaged by water. However, an iPad water damage repair plan may be used to fix the damages that were used by the backlight changing as a result of this problem.

A big part of repair involves checking on the inside of the iPad. This can be done by working with a putty knife to help with taking apart the small seal that keeps the iPad together with the metallic backing. This should be done to help loosen up the glass so it will be a little easier to take apart after it is opened up.

Tweezers are needed to get the LED wires removed. This includes getting them off of the logic board.

The LED wires have to be inspected to see how they are lighting up. This includes checking on whether or not any individual wire is damaged and is causing other lights to act up or to light up a little stronger than usual. This can be a real problem that has to be fixed carefully if the lighting is to actually work well in a given spot.

The backlight will have to be fixed by taking a look at the logic board after the LED wires are removed. This includes checking on the six small resistors on the board and the backlight chip used to get it all to work well. These chips have to be examined carefully in order to make sure that there are no problems associated with getting the board running as well as possible.

A new 4R7 coil might be required. This is used to power up the backlight to get the signals for light to work well. This has to be fixed properly in order to get the light to send itself out the right way without any obstructions. This can all work well if the lighting is fixed carefully.

The key about fixing the problem is to avoid bringing it to an Apple Store. The problem is that Apple does not have its own official way of fixing the problem just yet. The procedure listed earlier here is the clear way to go when getting the problem fixed right.

This procedure should work well no matter how the backlight got damaged. This can work well for water damage problems but any other issue can be handled too. This must be done to keep the backlight from bleeding out any further.

Leave a comment